ge space saver washer dryer troubleshooting

With the cables removed, you need to loosen the connection between the heating element and the drum. The cables should just unplug, but watch out for those that have a clip. To do this, take a photo of where all of the cables go, so you can put them back properly. You may find this easier to do by removing the entire heating box from the washer dryer. As such, you’d be wise to clean out the fan, too. There’s a good chance that the fan is also clogged with dirt, which prevents the air from being circulated. Use a tap to wash out your condenser How to clean a washer dryer’s fan Make sure that the water inlet is clean, so that water can flow in and through the condenser. You may find it useful to use a pipe cleaner to get in and dislodge any dirt that’s really stuck. Using a hose or tap, rinse out the condenser until all of the fluff is out. Inside, you’re likely to see build-up of fluff from your clothes, which is likely to be the cause of the problem. The condenser should pull out of its connection at the base of the washing machine, then move upwards to come clean away. With all screws removed, we could pull out the plastic condenser unit by first lifting out the heating element box. A set of pliers were used to remove the water hose. With our washer dryer, we first had to undo the screws holding the heating element in place, and next the screws holding the condenser in place. Getting the condenser out won’t be easy, with exact instructions differing from one appliance to the next. The condenser is usually at the back of the machine, under the heating element The rear panel is held in place with a series of screws: remove these and the panel should fold down. Once the screws are out, the top can be pulled away – it may require some force. The top usually comes off after having removed a couple of screws (you may need some Torx bits if standard crosshead or Phillips-head screws aren’t used). You’ll need to pull your machine forward to get access. Before you start, turn off the machine at the mains and the water supply, too. To get inside your washer dryer, you’ll need to remove the top and the rear. The layout of all washer dryers is usually fairly similar, although the screws can be in different places. The condenser is typically a plastic box that sits at the back of the washer dryer. If you’re DIY-savvy then in most instances you’ll be able to fix the issue yourself. However, if your washer dryer is leaving clothes hot and steamy, then it’s probably a result of a blockage somewhere. Likewise, you can confirm a broken fan using a multimeter, but for this too you’ll need an engineer to fit a new one. You can test this with a multimeter if you have one but in most cases, and once you’ve ruled out other problems, this will require the services of an engineer. If water isn’t flowing into the condenser, it’s usually because the valve is broken and needs replacing. There’s a blockage in the condenser, preventing water dripping down.There’s no water coming into the condenser.Now that we understand how a washer dryer works, there are three main reasons for your clothes failing to dry properly:

Why are my clothes hot and wet in a washer dryer?

Ge space saver washer dryer troubleshooting